FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Has anyone ever replaced a pilot shaft in a 1972 evinrude 25 horse? Mine is broke and I need to replace it. I have the part but was wondering how hard it was to replace.
OK I need some help. I have a 25 hosre 1970 Johnson outboard. I was having problems with it planing out so I cleaned the card on it. That all went well. So I took it out to the lake to see how it ran. It started great ran just fine but when I was going across the lake it felt like the motor was...
I am trying to change the prop on a 1970 johnson 25 hp motor. This is a sheer pin prop so I though that it would be easy but I can't get the prop off the shaft. Should the prop just slide off? Any Ideas.
Can some one help me. I have 2 motors for my 16' jon boat. One is a 1972 25 evinrude and the other is a 1965 9.5 evinrude. the 25 hasn't ran in about 2 years and the 9.5 has not been in the water for over 20 years. Both motors run great but I have spun both props on these motors. Is it because...
I have a 1975 Evinrude tiller stear 25 hp. The motor runs fine but when its in gear it will only push the boat at a slow speed. When I idle it up it won't push the boat. Can anyone help me out?
