FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Model # S130 TLRU
Recently i had an issue with the oil injection and have rectified the issue i am sure this is a temp sensor problem.
Ok here it goes while running the boat at 4200 + rpm's the alarm would sound and the motor would go into limp mode, so i have begun my investigations. i...
Ok I have spent days reading and testing everything that has been posted on here about the precision blend system. I am very mechanically inclined and have not found the issue yet . here is the sympton
Just purchased a flats boat and it runs great i have no issues at all . after a few moments...
i have the 454 out of my boat and rebuilt it . after all the machine work and assembling . it is ready to go. i turned the crank over by hand and it does not rotate the entire way. i then proceeded to pull the valve covers and take the pushrods out. it now turn over fine. my question is there...
i bought a 28' silverton it has a single 454 and a v drive for the trans. i disassembled the motor and it has been rebuilt before. it has a large cam gear to a single crank gear . this is reverse rotation. my question is that with someone being in the motor, probably more than once is it...
i have a nice 79 mako 21 it has an Evinrude Ocean Pro 175 the problem is i am having issues with the thing porpoising it takes a long time to plane maybe 8-12 seconds. once on plane it runs great except for when i hit a small wave maybe 2-3 ft it starts to bounce and will eventually settle down...
thanks for looking i appreciate all input on this issue.
I have a 95 Evinrude 175 Ocean Pro . it runs great when running. if i use the boat and then let it sit for a few days then go to use it again . it is a heck of a time to start it. takes forever. just the other day i ran 100 miles in it...
ok here it goes took mariner inline 1997 motor apart and seized a ring to the piston.; the problem is i can not find the piston i need. the motor is
1997 mariner 4 cyl inline 125 hp
the motor has been rebuilt before and the bore is .030 over now . the piston that came out of it says
"582" on...
ok had wiring issues with this boat . so anyhow got them straightened out today . everything works it starts stops and so on . put it in the water for fishing trip in the morning . starts right up everything good and ready . all of a sudden i notice i am not charging. i did install a new...
my 95 evinrude ocean pro 175 just developed this problem . it starts runs fine and has no issues other than it will not shut off. i checked the lanyard and disabled it ran it to a toggle to shut it oiff for the time being so i could use the boat . but it does not always work. sometime it will...
. hello every one ,
decided to get my mako it has an evinrude ocean pro 175 (1995) ready to run this weekend and take her out. everything has been fine with it , have had it several times no issues at all. yesterday i hooked up the tach and volts as well as water temp gauge . everything was...
Hello to everyone on this site i am newly registered here but have been reading the forums for years.
I have a question to pick your brains,
i just recently purchased a 19' trophy center console with a rebuilt 125 mariner on it. Yes i have the paperwork and talked to the marina that did the...
