FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Good day mates. I have replaced bearings and seals in my 1964 E-rud 28 hp gearcase. I put prop on for dry run and noticed that it does not seat aganist the seal housing. it is about 1/4" away. of course that is with the pin inserted. What can I do to correct this. I am worried about cavatating...
Good morning Mates. Well started into the lower unit of my 28 HP. Found several things to include a bad bearing. When I took my pinion gear out the roller bearings started falling out. The pinion gear looks like that of a 68 model versus my 64. Is this bearing incased? If so ,without a puller...
Good day Mates and God bless. I drained and put in new oil before the Week end, but when I checked it last night after two trips out, it was Milky looking. What is my problem? I have no leakage around the prop. The second problem with my 28 HP E-rud was surging at high speed. :confused:
Thanks...
Good day and God bless. I have a 14'6' long star with no ID number. Can any body enlighten me on the company. I know they where in Grand Prarie Texas and Bremen Indiana? It is Alum that I am about to start restoring.
Thanks much and kepp it between the banks.
Popsrose'
Tennessee Hick:rolleyes:
Good morning All and God bless.
My friend has a 35 HP, 1986, I think, (0A965285) that pumps water when it first starts then stops pumping water. Any body got any info on what to start with in repairs?
Thanks much!!
Popsrose'
TYennessee Hick:eek:
Al right guys, Here is one on me. I have got my old engine running good. After removal from water. I noticed a black drainage, from my lower unit water ports. Lower unit oil is fine. It is draining onto my blade. It this a carbon build up, or have I lost a seal some where?
Thanks much and God...
Good day and God bless. I was given a QS21 10 horse. Cleaned carb, cleaned and reset points. Replaced fuel lines. Got good fire. Set lower jet at 1 turn. Set upper jet at 1-1/2 turns. Cranked my but off and not even a wimper. Checked plugs and they were wet. (Flooded I think) Question, What is...
