Pmt133's latest activity

True. And as dad always said, the parts weren't always easy to get when they were in production. So I guess it doesn't matter that much...

At some point merc changed the GEN II but I'm pretty sure most of the gear sets and parts all work back to the early 70s. I was kind of...

As opposed to the Ford, GM and Stelantis parts obsolete for 2013 and older vehicles?

When the Admiral and I buy a 'permanent' resident a large barn or garage will be on the list of amenities . . . :LOL:

My lower is circa 1976 and has been wet stored until 2011. It got more corrosion damage on fresh water then it ever did in the bay.

Dad's 77 had some 1600 hours put on it between 85 and 95, which is quite unusual. On the flip side the 84 has about 900 on it since 98...

The ownership experience of the recreational boat owner and their boat is interesting to consider. Only a small % of these owners put...

Was only kidding. Dad built his whole pole barn for a year rent at that rate. I can't ever justify paying for storage of something at a...

Probably, with enough land, a barn could be built . . . but I'm maxed out on what the house/land can do. There is a place right near...

Fair enough. Also one of the many reasons I'm picking a place to disappear to when I can...

Received the new bolt and installed, so it's ready (I hope) :confused: When replacing the bolt I had to remove the step just inside to...

Pole barn.

From dad's musings wrenching, wellcrafts with volvos in the 70s/80s were about the worst to work on. Hated benches, hated fiberglass...

Finishing touches . . . I got the draw-strings installed. . . Earlier today, I ran some PG antifreeze through the flush port as...

A review of the MSDS sheets for both 2-4-C and Extreme grease show that while both greases are supplied by the same manufacturer, the...