FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Hello Guys,
Mariner 75
Engine: 75 ELPTO
SERIAL NR: OP121659
My propeller has quite a chunk out of one of the blades, I would like to replace it but cannot find any numbers of the prop at all! Its aluminium and has three blades -:confused:
I would like to replace it with a Stainless Steel...
Hello guys, wiring up the starter motor, there are three terminals the big one is obviously the one for battery and alternator. I just need some one to confirm which of the other two pins connects to the solenoid? One is labelled S and one is labelled R..... Cant make it out in the engine...
Hey Guys,
Removed my engine and noticed the shift cable was in a poor state, as were the bellows which were perished. Decided to replace the lot. (Alpha one unit)
When I removed the old shift cable from the housing the brass fitting ripped part of the thread out. I have brought a new shift...
Hello guys,
I have been offered another replacement block/bottom end to replace my cracked block, just can tell if the blocks are the same or not? Have looked at the engine numbers and tried looking at the mercruiser Service Bulletin 2005-08, but still can't figure it out.
Please could some...
Hello people,
I have just bought a Spirit 165, with a mercuriser 3.0l alpha one engine. The engine has a blown head gasket. I can see that water is coming out just below the inlet manifold. I ve had a look on here and can't find any threads about this topic.
I checked the compression which was...
