FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Ok guys I put new head gasket,exhaust gasket cleaned water passages put in new inpeller and motor seems to run good-The qestion I have is are the cylinder head and plugs going to get very hot while running-The side of the block feels ok I can lay my hand on it for awhile but the head I can only...
Another question, I have a 1975 4hp evinrude that was running a bit hot so I pulled the cylinder head and exhaust plate and found a piece of rubber in there-anyway when putting the powerhead and exhaust plate back on should I put a a high temp sealant on the gaskets? Also should I flat sand the...
Hi guys, I have a 1975 4hp evinrude #45B37A which Im going through and need to know the correct spark plug-They have a ngk B6s is this the right plug? Still waiting on my manual-Thanx in advance-would like the champion plug if able-
Wondering if someone could help me out here-I have a 1975 4 hp evinrude with a fixed high speed jet that was corroded and plugged up, in the process of opening I ruined the jet, I was wondering if I could replace with a high speed needle jet-Thanx in advance
New to site -Just got this motor nice little 2 cylinder-Waiting on manual but cant seem to locate vent plug on lower unit-found drain plug-anyone know-Thanx in advance
