Im
not sure either, I was thinking it shouldn’t because it’s the sensor input. Output is 5v then whatever comes out of oil sensor volts would read pressure. That’s my thinking. The troubleshooting in service manual saying it could be ecu. But I’m just making sure that’s it. Boat only has 55...
Hello, I have a boat that buzzes and sets high engine oil pressure. Checked about all can check. I’m wounding if it’s ecu? When bring it up on diagnostics laptop oil pressure reads 55 psi without motor running. I replace oil pressure switches. I have ohm the wires, from ecu to connector on...
Im needing to replace my 1984 150hp Johnson V6 powerhead. Would a 1979 200hp Evinrude V6 powerhead fit on my 150 base? Looks the same from looking at it.
Thanks
Mike
Have a 2004 MSX-150 jetski . Wont go full throttle. Runs fine at half throttle but thats it.Replaced System Module, PPU interface module,PPU and throttle body. So not sure what else to look at? Anyone had anything like this on a jetski? Its a Polaris.
Thanks
Thanks for the help, thats one of the problems with this style of carb no adjustments on carbs. I went back through the carbs again, will try starting it this morning.
Thanks again
Ok tried around 1000 idle. Still the same thing. Like i was saying it will idle for a sec or 2 then dies. If i keep hitting the choke right before stalls it will go back up to idle speed. Well run fine at full throttle. So not thinking fuel problems but idle acts like fuel problem.
