I recently rebuilt the carbs on my engine. In the process of removing the plate covering the carbs I broke a brass fitting with a very small ID hose is attached. The hose is part of a set of hoses that attach to the powerhead for each cylinder. It attaches by the head then again under the carbs...
I have an older 150 v6 that has 3 dual barrel carbs. The motor will not start with out spraying fuel into the carbs. I rebuilt all carbs and replaced all needle valves, replaced all hoses and installed screw clamps, repaired the fuel pump, installed a fuel preasure gauge in the lower card fuel...
Hi all, this is my first post. I have been working problems out of a used 150v6 i recently purchased.
The s/n on the lower end is a 1979 but the power head has been replaced so i can't tell what year it is.
Now to the problem, the guy I purchased the motor from said it needed a new water pump...
