Recent content by Nico van Wyk

  1. N

    5.0 gxi-j not starting

    Will a scanner pick up a faulty crank shaft positioning sensor?
  2. N

    5.0 gxi-j not starting

    Battery is a 600 ccc, so that is fine. Started to take out the plugs to crank it without plugs. Discovered that that these plug were never changed at all. Two of them are so full of rust that one actually broke off and the other one I can not even get the plug spanner to fit over it. The other...
  3. N

    5.0 gxi-j not starting

    How do u test the crank positioning sensor,if that is working or not. Do I just buy a new one.
  4. N

    5.0 gxi-j not starting

    What did u mean by scanner. What is the scanner?
  5. N

    5.0 gxi-j not starting

    Did put new terminals on Battery side. Wil check the ground on engine side Thx
  6. N

    5.0 gxi-j not starting

  7. N

    5.0 gxi-j not starting

    At the moment it cranks very slow. Could it be because it was standing this long. I did fit a new 80 anp battery
  8. N

    5.0 gxi-j not starting

    OK I will check for 12v and if RPM IS 300 or more when cranking. What happens if it's less then 300 sir?
  9. N

    5.0 gxi-j not starting

    Thanks for the reply. Do u mean the one That u tie on your arm before u go? That one I have tested and it works, clip is in and dashboard lights up when key is turned to on.
  10. N

    5.0 gxi-j not starting

    Staying in Belize and there is no one that can help me to fix my boat engine. Anyone with some feedback to why the engine cranks but will not start.I got the boat with the property and was standing for 5 years plus. Check the feul supply and that fine. Figure out that there is no spark at...
See more
Top