I have a 1974 25hp Evinrude. Yesterday when I put the boat in the water and attempted to pull start the motor, the pull rope initially grabbed the flywheel (per normal) and pulled all the way out and then would not retract. I tried to gently give it a few jerks to get it to recoil but it...
I have a 1970 60hp Johnson outboard. When it starts, it starts in forward. It should start in neutral. I also do not have reverse. I am assuming this is a "shift solenoid" issue, but not sure. Also not sure where (or if) in the lower unit this would be located. Could this be another issue...
So I have a 1970 60 HP Johnson. I am blowing the main fuse after the motor runs for about 3-5 minutes. The fuse holder itself gets very hot before it blows. The ignition switch is good (just replaced). I have found a couple of "baked" wires that were probably grounded. I have fixed those...
Can a bad rectifier cause the main 20 amp fuse to blow??? The tach functions fine. Trying to find the cause of the fuse blowing after startup. It can run for 1 minute and then blow, or sometimes as much as 5 minutes and then blow. VERY frustrating!!! Any help would be most appreciated!
I have a 1970, 60 hp Johnson outboard that blows the 20 amp main fuse after running for a couple of minutes. Initially found the red wire on the rectifier was cooked and broken. Fixed that and seemed to be fine for a day - tach now works after not working before. Then more blown fuses...
