I bought my boat with a hei car distributor on it I have a AQ260 volvo penta in a 1981 carver I'm installing a oem electronic distributor it has two wires coming off it and I'm not sure where they hook up I believe one goes to the coil or do they both go to coil one to the + and one to the - any...
I have a1992 yamaha t9.9 and it won't rev past idle cleaned carb checked fuel pump don't think its a fuel problem if my oil sending unit is bad could it go into limp mode starts good idles smooth just won't rev much past idle
I have a 1992 yamaha T 9.9 4 stroke it starts and idles fine but when I put it in gear and try to rev up it starts to chug almost seems like its choking took carb apart and cleaned it did not make any difference seems to be getting enough gas new gas filter pump is pumping good could the black...
I just recently bought a 1992 26 foot galactic boat can't find any information out about this boat it has a cuddy cabin it is a fiberglass boat with a arch on it powered by a 454 volvo penta dp drive . the title says galactic on it but I can't find any manufacture name on boat. I did a google...
I have a1981 26ft carver that I use for salmon fishing on lake michigan I know that a yamaha t8 would push it but would yamaha f6 be big enough I run about 2-2.5 mph
I have a 81 volvo penta aq260a just bought recently and it has a electronic distributor just wondering if I can use the same plugs as when there were points I believe that the coil on a point type distributor puts out about 20000 volts and gms electronic puts out 40000 volts
I have a 81 volvo penta aq260a and it will start but when I turn the key to run it stops I checked the switch and it is ok I can hook a wire from the battery to distributor and keep it running. just wondering if there may be a safety that won't let it keep running when running oil pressure ok...
