FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
The housing is older but if anything just rusty not corroded. I also noticed the thermostats have a small open area to bleed some water through, but its very small in comparison to the bleed hole in the housing.
Yes there are only 3 hoses, #1 sea water in top left of thermostat housing, #2 large u shaped hose to pump, and #3 a short jumper hose from right side of thermostat housing to manifold. I am aware of the bypass hole in the housing and it is clear theres plenty of cold water going to the manifold.
Yes it happens on the muffs as well. I attempted to warm up the engine to set initial timing and adjust carburetor. It would not come up to operating temperature on muffs, so it has been at the lake since with the same issues. NOTE: I dont remember much water coming out of the prop area while...
Hello all, need help with a 3.0l OMC sterndrive in a 28' Harris pontoon boat. Long time reader first time poster :) Compression at 120 across the board. Rebuilt engine (bought from retailer not self done), new manifold, new thermostat (3x, one $40 dollar mercruiser model), All new gaskets and...
