I'm re-sealing the lower unit and found 0.022 inch end play on the prop shaft. This seems excessive because the tapered bearing moves out of the cone slightly.
What is right? What should I be seeing for in and out movement? Is this a matter of shimming or replacing parts?
Re: 1958 rde-19c Seahorse 35
Thanks for the information. With the cowl installed, the gap at the front is about 1/4 inch and the gap at the rear is about 1/2 inch. The casting numbers on the blue head are 307306 and 307759. The symbol next to the number looks like a"M" The second picture shows...
I am reviving a 1958 Johnson RDE-19C. The forums have been a great source of info. The unit was going to the dump unless I wanted it..:) So far I've replaced the coils and serviced the carburetor. Compression is very good and I started it for the first time yesterday... I find the cylinder...