I found this small metal piece dangling in the bilge, blocking the drain - any idea where it comes from? I can't see anything immediately broken/not working. Aluminum, slightly curved, Mercruiser 3.0.
That's what I thought as well, that's why I find it very weird that replacing the gimbal fixed it. I did not crack open the u-joints but will monitor closely for any noises.
So I took a chance and replaced the gimbal, figured it's much easier to do. I was not really expecting that to fix it, but it did. So weird!
The old gimbal still feels smooth, absolutely no play or roughness whatsoever. I took the boat out today and noises were all gone. I was also leaning...
I'm confused by this - got the gasket based on the engine serial, but seems the ports are still a bit smaller too. I'm worried because the previous gasket melted exactly at those ports that were covered:
Here's how my manifold looks:
Looks like this new gasket is what comes in the kit as...
I started getting knocking noises when turning the steering wheel, at about 60* either left and right turns. It gets slightly louder as the angle increases.
Here's what I did
- took drive out, checked the u-joints - they turn smoothly, no play (non-greasable type)
- checked alignment - looks...
Hi folks, Thanks for the suggestions - just wanted to give an update that it was indeed an exhaust leak, the exhaust manifold gasket was blown.
Looks like the gasket itself was not the right fit, could this have been the reason?
Also, I remember reading somewhere that these green gaskets are...
Hey folks, I started getting this weird knocking sound last time I went out. Thought it's valve clatter so I did an adjustment (#1 was just slightly loose, but not by much). That didn't fix it unfortunately. Any suggestions what I should be checking next?
Mercruiser 3.0 Knocking Sound
I'm...
I did that today, wire-brushed and sanded down to shiny metal all the connections. But still the same problem :( Here's a cold start video, once I touch the jumpers it immediately starts up...
No points, the newer electronic one (I think).
Replaced the slave, sorry for the confusion. Jumping the slave posts immediately starts it, it doesn't even do a full turn. When using the key it's cranking and turning over for a long time, or it takes 7-8 tries to get it to start.
Thanks, I'll have another go at it tomorrow - cleaned and...
I'm dealing with this weird situation where the boat is hard to start when using the key, but if I short the 2 main slave solenoid terminals it fires right up. When using the key, the engine cranks fine, but I can barely get it to start after a lot of retries. I checked the small solenoid...
So it seems there should have been some o-rings on those bolts (part #25-25429). I've used some that I had around until I get the correct size and the leak seems to have stopped.
Hi folks, I'm dealing with an oil leak at the bottom of the push rod cover for a 3.0L. I've replaced the cover gasket (with a cork one) and that fixed the leak around the cover.
But now I have oil leaking around 2 of the bolts. Any suggestions on how to deal with that? I'm afraid of over...