Recent content by Mohawkmtrs

  1. M

    1986 Mercury 9.8 110 outboard

    Rope Start or Electric Start?
  2. M

    1973?

    85ESL73M= 1973 85HP Johnson as per maxrules.com
  3. M

    Honda BF50L

    You're right 5hp. Frame Number BF50L-1000001 and up Model Year 1985
  4. M

    Evinrude 15 Part ID - Help!

    #39 in gearcase parts diagram Part No. 318972 Seal, Impeller Housing to Driveshaft
  5. M

    Mariner 25hp year identification

    I get: Model 25M Serial Number 648-11671 - 648-14070 Year 1974
  6. M

    What do these knobs do?

    1960 Impala 2-door hardtop.
  7. M

    Spirit 25hp

    Nearest I can figure/find out: 2502 = Horsepower/Generation F = 1989 (model year) 10378 = Serial Number For parts, call your local Yamaha Marine Dealer.
  8. M

    Johnson 1995 70hp no spark

    No...not normal. Brown to brown-yellow should be 750-950 ohms.
  9. M

    2006 merc 40 4 stroke

    Bingo! I had an older Honda in the shop with the very same symtoms. Turned out the exhaust manifold had a hole burned through...Too bad the part was NLA and was not financially feasible to remove the powerhead.
  10. M

    Mercarb 2BBL vacuum hose?

    Normally connected to the fuel pump with a see-through hose (NOT the fuel line). This hose allows the skipper to view the condition of the fuel pump diaphram. If you see fuel in the hose, you have a ruptured diaphram.
  11. M

    Free Mercury Tower of Power

    Also note that this motor is suffering from the all-too-common "Mercury Wiring Insulation Rot".
  12. M

    OMC SEA DRIVE-Tilt fluid location-150HP V4 1990

    4th picture in (IMG 6852)...see the flush-mounted, slotted screw? That's the fill screw.
  13. M

    OMC SEA DRIVE-Tilt fluid location-150HP V4 1990

    If tilt goes up and down, your pump appears to be working. Try operating pump up and down a few times to bleed any possible air in the cylinder(s).
  14. M

    OMC SEA DRIVE-Tilt fluid location-150HP V4 1990

    See those hydraulic lines on the left? Follow them back to the pump.
  15. M

    OMC SEA DRIVE-Tilt fluid location-150HP V4 1990

    The motor drives the pump, the pump pushes the hydraulic fluid to the cylinder(s)...the fill screw is on the pump.
See more
Top