FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Checked the voltage and sending wires all good. So I drilled a small hole on the side used a coat hanger to move the needle. It was really stiff but about after a few min of working it around it was nice and loose. Hooked it back up abd it works. Sticky needle.
Thanks for the help.
Hi. Thanks for the reply. So I went out an looked for it and found a cluster of wires with a purple, grey, brown, and black. The harness has 4 connectors. One was going to the fuel gauge and the other 3 were not hooked up. The end of the connector of all three would fit my rpm gauge. Here is a...
I recently bought a 2005 Smoker Craft with a 50hp Mercury outboard. Runs great. However the rpm gauge is not connected. I see several wire harnesses in the back (3 look like the same connector) but I’m not sure which one it is. Any thoughts?
