Mc Tool's latest activity

I dunno , Id probly crap out in that heat before the saw did ( is this where we link over to the low alcohol beer thread 😆)from...

Unless you are carving a Tiki from a palm tree carcass in 95 degree heat. BTDT

It's hard to kill a still.

cheap 12 volt tach plus a cheep buck-boost. https://www.amazon.com/DROK-5-5-30V-Adjustable-Regulator-Converter/dp/B07VNDGFT6?th=1

On the scale of things outboard motors are pretty low stress . Ie my 90hp yamaha was 1170cc whereas a 2 stroke moto gp bike could poke...

50:50 trans fluid and acetone is a very good penetrant /solvent that has free'd many a stuck piston . A bit if trans fluid wont hurt...

Can't be as bad as people using starting fluid on a 2 stroke.

pictures are required. You musta missed the fine print in the rules.... :-)

I can't really see your but I put right angle ones on mine because the access was blocked. Might work on yours.

On larger engines, almost all the timing advance is in before the carb is even cracked off of idle, and then once max advance has...

Woohoo! I say go for it Dude , last time I seen a Arduino it was getting chased by a hungry Valvoline 😆

I think that if you have been using good quality oil there would be no point . I had a 2009 toyota with the 2azfe ,it had done...

I wouldnt . I have seen the arse fall out of a boat full of people ," blink and you miss it " sort of thing . One second the boat was...

Have insurance and wear PFDs. It may be ok, it may sink Since rot starts at the keel and goes up, and the floor rots 10 years after...

These things dont work like you might think is logical . From an idle , motor ticking over ( the idle mix has been set right ) when...