Recent content by lynnboy021

  1. lynnboy021

    current to outdrives...

    my bro in law has a 36 italian boat he bought from someone in the satates well long story short the boat was converted from 220v to 110v and a new battery chager also... so he leaves his boat in the water all summer long and his outdrives are getting really bad by the saltwater eating them away...
  2. lynnboy021

    in search of a new motor

    the motor that i have now has a cast number 10227196 and its a 95 v6 4.3 vortex.... my question is what truck motor can i use for my swap? i know i will have to change the heads and i think the cam and the freeze plugs but i am s\just stuck on type of truck and what years i can use...... stupid...
  3. lynnboy021

    I need 4 inch lift

    I have a trailer that I needed more height so i had under axle springs and I converted to on top of axle... thought I would get the height I was looking for, I did not.... so my question is I need another 4 inch left can I put lift blocks? I will use 2 2 inch blocks to make 4 inch lift, will...
  4. lynnboy021

    mercury 90hp wont run

    i have a mercury 120 3 cyl f14 sea ryder jetboat and i already installed new red stator, new plugs and rebuilt fuel pump.... so my problem i am having is that the motor just cranks and cranks it does not wanna start...... carbs was just rebuilt a week ago by a pro and i have 120 psi on all 3...
  5. lynnboy021

    97 ocean runner info

    i am having problems with a 97 Johnson ocean runner 200hp. it starts fine on land then when i put the boat on the water it stalls out... i need to know what the compression is or if i can download a manual thanks...
  6. lynnboy021

    02 mercury 120 m2 v6

    There is a nipple under the starter I don't know where it goes..... anyone knows???
  7. lynnboy021

    ground to boat

    Do I need to ground my ac grounds to the boat like my DC grounds are????
  8. lynnboy021

    96 mercury sport jet 120

    My black stator was not giving me spark and I was reading that I needed to replace it with the updated red ones.... so I bought a red one but it only comes with 4 wires and not 6 like my black has... do I need to buy something else or is this the wrong part???
  9. lynnboy021

    96 mercury sport jet 120

    I have rusty water on number 3 and 4 cylinders. .. head gasket looks good but the exhaust does not come out at all and yes all bolts are removed. ... can the motor be cracked and allowing water to get in the cylinders? ??
  10. lynnboy021

    Cylinder head

    My friend needs a cylinder head for his v8 1990 merc so my question is can I use a 1990 truck head???
  11. lynnboy021

    non stop emails

    I keep getting blank emails from iboats does anyone else? ???
  12. lynnboy021

    trailer lights

    I have a new light setup with wires and the problem i am having is when i connect my 4 pin flat to 7 round adapter to my truck my trailer lights don't work too good.... they are to dim and when i turn left it works fine but when i apply the breaks the lights go dim and the right light starts to...
  13. lynnboy021

    Where should my boat sit on the trailer??

    I have a 22.9 sunbird barletta on top of a ez loader roller trailer.. my question is how far should my boat stick out the trailer or should the back rollers be right on the edge of the boat??? My towing vehicle is a 02 chevy avalanche
  14. lynnboy021

    rochester 2bbl carb

    Does all rochester carburetor needle and seat have a spring inside the needle? ??
  15. lynnboy021

    Never ends with this boat.....

    88 Chevy omc 305. ..... out drive fluid is leaking out where you put the muffs.... question if you overfilled the drive and started up the motor can the fluid go where you put the muffs on?????
See more
Top