FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Blew reverse gear, probably nothing major; about 450 hours on a rebuild from a shop in Ft Worth, motor screams, new volt reg, starter, water pump...Motor is complete, with control, switch, ......Motor has CLEAN TX title...
$500
Anyone have the idle screw settings for this motor. Carbs were rebuilt before I bought it. The manual I have does not have the settings, that I can find. Motor runs great, just a little shake and shimmer at about 800-1000 rpm in gear, coming off of idle. I have cleaned it up some by screwing...
Finally spashed yesterday for a few hours of testing. Only able to get to about 4900-5000 a WOT, @ 43 MPH on GPS, trimmed out and light on fuel and equipment on several runs. (170 Proline CC). I am turning a 20 inch SS prop, I plan on trying try my 19 aluminum next trip out.
However I did...
Ok, just completed an install with a low hour (159) 2004 Yamaha 115TLRC. New harness, new keyswitch, new multi munction tach with adapter harness, new 704 binnacle. Oil levels and lights-fine, motor cranks over, trim works. Turn on the key, Tach flashes, then settles in, but the overheat...
