Recent content by ktime70

  1. K

    1988 evinrude 120hp - slow to accelerate and gearbox problem

    Hello guys, ​About a year ago I took the 1988 evinrude 120hp looper off the transom of our boat to replace a steering cable. Due to impending bad weather, I removed all cables from it so I could store the engine in the garage while I waited for parts. After finally getting it back together, and...
  2. K

    Evinrude 120 Looper water not pumping?

    Hi all, Due to a gearbox issue (shift collar jumping), I pulled my lower unit and bolted up a good second hand one. It selects gears fine, and turns the drive shaft, however the pump does not pump any water out the pee hole. water isn't even getting as high as the powerhead. the waterpump on...
  3. K

    Evinrude 1989 120hp looper hard starting with a twist

    Hello all, I have owned my 120 looper on a 17 foot boat for about a year now. I use it almost every weekend, often twice in a weekend. When i bought it, it started first turn of the key every time, and ran really well. I had lower unit drama's which i've posted about here, that i have solved...
  4. K

    120 Looper very occasional hesitation

    My 1989 V4 looper has been having a consistent "miss" or hesitation. Has plenty of power to get out of the hole, Idles fine. Basically, at WOT, the motor hiccups once every minute and a half, and then runs perfectly again. the hiccup feels like a miss on one cylinder for momentarily. enough...
  5. K

    how to identify charging sytem on 1989 120hp looper

    Hi Guys, I have a 1989 v4 120hp evinrude looper (australian built if it matters) i just bought, and i need to buy a new regulator - rectifier for the motor. Most parts catalogues show that the standard charging system is 10 amp, but there was an accessory 35 amp charging system available. both...
Top