FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
For starters the my back story.
Purchased used boat with Yamaha stern drives as a project. The coil packs were bad so I figured my easiest and cheapest alternative was to losses the YEMS engine management system and go with the simple dizzy and ignition coil and new gauges. Igot everything...
Soooo,
I want to repair the dock. I will need a barge to complete my project. The excavator is 1800 lbs so the smallest spud barge I can find will do 60x24. Will I need a Captain to move the barge if it's my barge???
If this goes well I may look to work for profit in this field for a the...
Ok well the boat made it thru most of the season. With a ton a help from the experts on this forum. Now I have another question.
I was not getting much power from the starboard motor. Idled good and ran under load but with a load won't get past 2500 rpm. I rebuilt the carb because the...
Hello all,
Hoping you guess can help me out on this one. I'm looking for a Yamaha shift Interrupts switch for a Yamaha sterndrive.
Part # 6T0-8259F-00-00
Or any suggestions on a work around.
First off, thanks for the help with my Yems trouble. I ended up swapping that mess out as you guys reccommeded. The swap went good got it running and the timing in order. I had to get new tachs as they ran through the yems computer. While installing the new tach went to check the port motor...
Hello all,
well
When I purchased the boat it had spark in both motors and would fire. Took it home a set to work getting the power tilt and trim and trim tabs fuctioning with a bit of help from the forums. I also cleaned a few connections, checked fluids and impeller. went to start the motor...
