Jut got my motor running yesterday...Got home today and looked in the tank that I had it in and there was a lot of oil.. Pulled the motor out of the tank and wiped it down and noticed oil coming from a small hole next to the full oil level screw I dont know if this is normal or not and if not...
1976 25hp Evinrude still wont fire... Replaced the driver coil cleaned and adjusted points.. The motor ran 2 years ago and has been sitting. Model Number 25602
I have a 1976 25hp Evinrude that doesnt fire any troubleshooting procedures on this would be very much appreciated.
Model Number is 25602E..........E0005918..... I am new to this forum and also new to outboard motors.. I am a diesel mechanic so not familiar with outboard motors.
