FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I am in the process of doing the decarb process with the lower unit in a 55gal trash can and got to the part of spraying sea foam in the carbs. I am noticing that there are slight poping sounds like what the reeds sound like when you barely touch them with your fingers, but it does it eraticly...
Hello all I have checked comp. 145-150 all across, replace surface gap plugs with proper plugs installed thermostate where there wasent one, cleaned the carbs twice and made sure the 3 little holes are open(30 jet in the top 35 for the intermediate ? for main could not remove but clean) I set...
I know that i have searched this and seen people say no it wont work but I found this.
http://www.instructables.com/id/Automobile-Tachometer-on-an-outboard/
I was wondering if others would think that this would work. I think that all he is doing is making it to where it is able to read...
just got this boat from my stepfather it is a 75 glasstron 15ft with a 70hp johnson motor on it. couple of questions when he had it he said that when you would first take off the rear would dive a lot and not go hardly at all until you had some one go to the front and even it out, he said that...
