FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Re: Mercruiser Alternator wiring in Dual Battery Isolator need some advice
Thanks - I think I am on the right track with wiring the orange alternator charge wire directly to battery 1 (after disconnecting from the starter motor) due to the Perko switch. It is the same principal as the...
I am fitting a Dual Battery Isolator to a Bayliner 2355 twin batterys with a Perko switch. The electronic isolater will ensure battery one is charged then switch over to battery two . The Perko switch only allow one battery to charge depending in the position of the switch 1 or 2. I want to know...
Hello All, I am fitting a good second hand motor all good except trim is not working the trim motor is working on both switches however the engine dosen't move. It is all the way down at the moment I think it may have had the hydralic fliud removed for transport I have tried to remove the manual...
I have just completed rebuild on a 1996 V6 2bl carb and I am upgrading to dry joint exhausts. I purchased a mercury set taken off a new motor and they have a water outlet on the riser. How should I plumb the this outlet or do I just block it off.
