Took the boat out and guage did not register any oil pressure. Went back in and used a multi-meter for OHMS test. Sender read 248ohms with guage wire off, motor not running. Started motor, with guage wire off and got a jumbled reading....went from 228 down to 161 and then back to 228. Put on...
Re: Morse side control for Merc 3.0
DThe three pictures show the channel in 1.neutral ...2. inThrottle only at point where the round guide wheel starts to activate throttle. 3 is a close-up of picture two.
If this is the way it works and no adjustment can be made then I will live with it...
Re: Morse side control for Merc 3.0
First is neutral, second is pulled out for throttle only and that is where it starts. Third is WOT and fourth is 1st click in gear.
Last picture shows channel I was talking about. GO TO NEXT POST.
Have a question. I pull out the handle to put it in throttle only. I have to push it a 1/4 of the arc to get it to engage. Is there an adjustment I can do so it starts working earlier? I have looked at the back of the unit and the slot that the roller rides in to move the throttle forward...
Newbee here.
Just got home with a 1994 Regal Valanti 176 SE. Serial No> Engine OF143158, Tansom OF326816, Drive OF251201.
Boat needs side panels remade and a good general cleaning. Engine runs fine, shifts fine, oil is lignt brown in color.
Just wondering if anybody has any advice. Floor was...
