I had to do some work on my yamaha and after putting back together, I failed to secure the throttle and shift cables. I installed them back into the rubber piece and bolted it down but this does not secure the cables. What did i do wrong? What holds them in place?
I have a yamaha 2002 60hp with the electro thermal valve. it seems to work on the bench but can not figure out why it wont start the motor when activated. In the test it taks several minutes for it the be fully extended. Can anyone explain why it doesnt work instantly? If i use the emergency red...
Can not get prime start enrichment system To work on my 2002 Yanmaha 60TLRA. I do not get any volts when I try pushing the key in while starting or when ignition on. Can anyone help me to diagnose this? :confused:
I prime the fuel bulb tight but when i go to start it take about 30 seconds to start. Once it started it runs for a lil bit idle and then stalls. Starts right up again but wont idle long. What do you think is the problem?