Jakem's latest activity

  • J
    Jakem replied to the thread No start with key.
    302...yes I checked fuses
  • J
    Jakem replied to the thread No start with key.
    Right the issue is no crank with key. I will check for voltage and see what I got
  • J
    Jakem posted the thread No start with key in Electrical, Electronics, Audio and Trolling Motors.
    Good day...boat was starting fine with key...and now will not...I replaced soliniod thinking may be then issue...still no...I can jump...
  • J
    Jakem replied to the thread Trailer dog tracking.
    Ok I will thanks for the info
  • J
    Jakem replied to the thread Trailer dog tracking.
    Gotcha thanks
  • J
    Jakem replied to the thread Trailer dog tracking.
    Makes sense...thanks
  • J
    Jakem replied to the thread Trailer dog tracking.
    It doesn't sway back and forth just aims to the curb it seems...not sure how to check tounge weight or adjust it
  • J
    Jakem posted the thread Trailer dog tracking in Trailers and Towing.
    Good day. My trailer doesn't seem to go down the road straight. When I'm pulling it looks like in the mirror that it's kinds doing the...
  • J
    Jakem replied to the thread Y pipe.
    I'm going to pull it back to dock
  • J
    Jakem replied to the thread Y pipe.
    Like the oil pan or what...how deep can or does it need to go
  • J
    Jakem replied to the thread Y pipe.
    I was looking back towards inside of transom so by left side I meant starboard side..I am going to take it back to water tomorrow and...
  • J
    Jakem replied to the thread Y pipe.
    Alright so I've ran boat for an hour in driveway...no leak...my conclusion is it's not y pipe...I have checked all bellows and snughed...
  • J
    Jakem replied to the thread Y pipe.
    Early alpha 1 sorry
  • J
    Jakem posted the thread Y pipe in Mercury MerCruiser Sterndrives & Engines.
    Ok so after reinstalling a new bell housing gasket...housing..outdrive...y pipe...and engine. I had it fired up on hose and there was no...
  • J
    Jakem replied to the thread Stringers.
    That is kinda what I figured. I can honestly say it has way more strength now then it did when I pulled it apart no bulkheads...rotten...
Show older items
Top