FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Just purchased a 1995 Four Winns with a OMC Cobra drive. The engine was replaced with a 1989 OMC 502APRMED. What firing order should be used? The last owner could not get it running and sold the boat very cheaply
Purchased a new Mercruiser Bravo crate engine 5.7 325 hp. Installed new manifolds,risers, water pump, hoses and thermostat. The boat ran fine for 29.5 hours and now has water coming out of #8 cylinder. Compression test ranges from 60psi to 125psi, none higher. Mercruiser says that I detonated...
Just installed a new complete engine Mercruiser Bravo 325hp. Replaced an 0K027540 with a Weber carb. The new engine choke wire purple/yellow near the alternator has a barrel push on connector. Does this go to the "AC tap" for the tach on the back of a Mando alternator?
Have a 97 Mercruiser 5.7 LX 4bbl with a Bravo 1. Have a misfire and was wondering if a compression test can be done with the exhaust manifolds and riser removed? Would sure make life easy.
Have a 1997 5.7 liter with a mechanical fuel pump that needs to be changed. My question is there a way to rotate the engine so that the fuel pump push rod is at the lowest part of the cam lobe before removal?
Just purchased a used Sea Ox with a 98 Johnson 150 model number J150FSXECR. The seller had it in for a charging problem and purchased a new regulator/rectifier assembly and it needs to be installed. Where is the reg/rec located. I can not seem to located anything that looks like the new one...
