FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Hi Guys,
I have a 1987 175hp Evinrude V6 outboard. I have attached a diagram that I was finally able to find after buying a factory service repair manual.
1. As marked on the diagram under the carbs there are check valves. These valves all flow in outward direction. I have cleaned all of these...
Hi Guys!,
I used a syphon pump to pump gas out of my tank, there was water in it. I have about an 1/8" of fuel remaining. Is there any tricks or tips to get this little bit out? the hole for the fuel gauge is to small to stuff a rag down it. it is under the floor so removing the tank is not an...
Hi guys,
I have a 1987 175 Evinrude (E175TXCUA) I have a couple of issues.
1. With the VRO pump removed what is the recommended fuel oil ratio mixture.
2. I had the carbs rebuilt and the vacuum lines / fuel recirculation lines were not marked, I cannot find a manual that matches the check...
I have a 1987 Evinrude 175hp outboard. I got it with the carbs rebuilt and installed. The person who took it apart did not note the routing of these hoses before removing them. I have looked in two manuals and the design they show for the fuel recirculation hoses does not match. According to...
