Recent content by hitace

  1. hitace

    location of yamaha thermostat??2006 225HP

    can any one tell me where a thermostat is located on a 2006 225HP Yamaha Thanks!@
  2. hitace

    Evinrude's 100th Anniversary video

    Evinrude's 100th Anniversary video. really neat video.Take a trip to the past.Losts of vintage outboards shown. http://www.youtube.com/watch?v=We5YIEgRhRE
  3. hitace

    help I.D. older evinrude :)

    model# is 6502M serial# is E03323 thanks
  4. hitace

    no drain screw???

    :confused: I am working on a mid 80's 45 HP mariner outboard and there is no drain screw for the lower unit.theres a screw that says flush and theres a screw that says vent.where do you drain it and where do you refill it?thanks
  5. hitace

    HELP ID this motor

    model E10SE LCID serial E0001806. thanks
  6. hitace

    a typical yamaha

    http://www.youtube.com/watch?v=4ckq7xj1TVo maybe next time she will buy a good old OMC.If she lives. I know i am going to get bashed on this one.
  7. hitace

    homemade lower end seals?

    how would someone make lower end seals my 1952 johnson keeps leaking lower end oil same with my 1955 evinrude :(
  8. hitace

    OMC gold mine

    "http://cgi.ebay.com/ebaymotors/OMC-Evinrude-Johnson-I-O-Assorted-Parts-324-part-s_W0QQcmdZViewItemQQcategoryZ50442QQihZ016QQitemZ260153098734QQrdZ1QQsspagenameZWDVW" need more money :mad:
  9. hitace

    will J4C or J6C work as a replacement for J5J

    will J4C or J6C work as a replacement for J5J?
  10. hitace

    gas ratio question for really old outboard

    what would be the ratio for a 1939 johnson is it 24:1 or will i have to do 16:1
  11. hitace

    exhaust plate stopping outboard from starting?

    could a few pin holes in the exhaust plate stop a outboard from starting?
  12. hitace

    setting timing on old outboards

    how would you set the timing on a 1955 evinrude or is fixed timing?
  13. hitace

    rebuild old evinrude just will not start

    i just got done rebuilding my first outboard its a 1955 7.5 hp evinrude when I found it it was locked up.i put on some new rings and it freed right up so i soaked and rebuild the carb put a gasket kit on put on a new impeller put on new points and condesors new plug wires and got it all back...
  14. hitace

    1956 evinrude to the rescue

    http://www.youtube.com/watch?v=Vt1lcuoFbRE
  15. hitace

    honing cylinders

    i want to hone the cylinders on one of my old outboards i was told a rigid hone would be much better to use then a ball hone.does anyone have any suggestions on where to get the stuff for honing.and whats everything i am going to need
See more
Top