FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Went on a sea trial for the 2002 Sea Pro 1900 I'm considering buying. Noticed the tach was jumping around a little bit when we first running out - didn't notice what the voltmeter was reading. Then after a stop for a few casts, we headed back in and I noticed the voltmeter was dead - pegged at...
Hello all. I am looking at a Sea Pro SV1900 with a F115. The owner says he didn't like how light one of the plugs looked so he pulled the fuel rail and injectors and had the injectors ultrasonically cleaned.
Today we did a compression test on it - 170 to 175 psi in all cylinders, so that...
Pulled the idle stabilizer box recently and reset the timing - 5 deg primary and 19 deg high speed. I have it idling down to about 600-700 rpm in gear (800 to 900 in neutral). I had to adjust the idle up that far to keep it from dying out. Idle speed screws are turned out 1 3/4 turns. The...
First, I am not trying to sell here and apologize in advance if this post goes over the line in that respect.
After installing a rebuilt powerhead in my '88 115 L6, the old one with 2 low/no compression cylinders sits in the garage holding the floor down. Seems like a waste of good parts and...
I repaired a corroded red/white wire at switch box at the beginning of the summer. Now I see from doing some research that the box isn't really needed and I don't think my motor needs it, so I'm planning to pull it out.
Question is, should I remove or leave the white/black wire that connects...
This is my first post here, so first an introduction, I am from SW MI and have owned my 1988 Fisher 18FS with a 1988 Merc 115 L6 since new. I have run across this site a few times when searching the web for info and appreciate all the advice you folks give to those in need. I hope someone can...
