That sounds like it may be the issue … possible lake weeds clogged up the intake? There are a ton of weeds this year. Manifolds and risers are new as of last year so doubt that’s an issue. Motor is 2004 but new block in 2016 by previous owner. Consistently runs at normal temp. Going out...
Hey all, Was pulling the kids on the tube today at about 3200 rpm for about 30 mins or so, stopped to get the kids in the boat and got a high temp alarm…. Temp gauge went up to about 180ish. I shut down and waited a few mins, started back up and idled to our cove at about 1500 rpm’s and temp...
Alldodge… replaced the ECM and MAP today and seems to have done the trick. Hooked the Rinda up and temp at startup was high 80’s and idle was better. Real test will be the next time I start cold and hopefully it’ll start up on the first try without stalling. Thanks again
Sorry bout all the questions… but confused on which is the proper sensor. Am I looking at 19 or 20. I think 19 is on the tstat housing and 20 is on the exhaust manifolds - one on each side.
Sorry pics are out of order and I didn’t include the idle info when I was at idle on the throttle - I’ve attached. The 950 shows “desired idle speed” when I bumped the throttle to 1500 rpms. Not sure why that would be higher when the throttle is bumped. Would think desired idle would always...
Thanks for the reply. Would you know what the normal output for the IAC should be? I’m getting 22-25 at idle and 35 at 1500 rpm. Trying to diagnose a hard starting condition when cold. Some photos of the diagnostic info attached
Hi all,
2004 5.0gxi-D. Looking for all the specs that I can compare techmate pro output to. Not finding anything in any of the manuals I have. Suggestions?
Thanks
Howdy all, after changing manifolds/risers and full tune up, I fired up the boat in the driveway and had a no start condition. Motor cranked and sounded like it wanted to start but dies... went through all my work and found new #8 plug wire broken at the plug end, so replaced and it started up...
Changing out my impeller and snapped one of the screws. Housing is brass?? Guess the screws are as well. Having a hard time finding replacements in brass. They are M5-.8 x12mm. What other metal can i use that won’t cause an issue?