Recent content by froggy1150

  1. F

    Boat lift maintenance

    Open gear grease on the open gear. And if it were me I would use a moly grease for the pillow blocks and bearings/bushings
  2. F

    Marine Insurance

    No Mr jim..... agents seem to die after writing policy's for you ☠️
  3. F

    Marine Insurance

    Jim... I'm not an agent but if I was I would NEVER write you a policy🤣 I have progressive and boat us. Progressive was super cheap and boat us Mainly for their tow ins
  4. F

    Restoring 1988 19’ bayliner capri

    If it has no wax (dont sound right.... probably has wax in it and don't require more...)rubbing acetone on a spot and see if it gets soft and tacky. If so you could probably just go over it after a full wipe down. You would need to do a full wipe down with acetone before sanding anyway if it had...
  5. F

    Surprise My electric car is not charged.

    I remember growing up we were going to go into the next ice age and they were trying to figure out how to heat the planet. Next is we are overheating. Now it's just "change". The planet has always had temperature fluctuations, even before the industrial revolution. Who can prove its just man...
  6. F

    1971 Reinell

    I have your boats little 22ft sister. It has the dwarf size cabin, not like yours with all the head room but at 5'5" I'm good. I am willing to bet your whole boat structure is rotten. Mine was.
  7. F

    hull repair needed along lower rake

    After you bulletproof the glass contemplate 4lb structural foam for both of those areas
  8. F

    DIY - Canvas Enclosure

    You never cease to impress
  9. F

    Stringer install

    So glass cloth is the strength. The resin is the glue. Peanut butter is resin and cabosil. Cabosil is a thickening agent. Turns the liquid to a putty so it can hold its shape til it cures. Depending on your needs you adjust to the consistency you like. I would add a little chopped strand in my...
  10. F

    Stringer install

    Most important is no voids and a nice gradual taper in your tabbing. I used peanut butter. I 100% wrapped every piece of wood individually then set in place with the aid of clamps and supports, using pb. Nice thing about using pb is if you do all your tabbing at the same time when you bubble...
  11. F

    Stringer install

    You use some type of filler between the stringer and the hull to avoid hard spots. If the stringer is touching in a spot and then not it will allow things to flex differently and then crack.The tabbing is the strength and has to get thinner on every layer to allow things to flex gradually like a...
  12. F

    Restoring 1988 19’ bayliner capri

    You can cut the foam into manageable chunks with a oscillating saw
  13. F

    Restoring 1988 19’ bayliner capri

    I used all kinds of things including a trenching shovel and pickaxe. Whatever works. I had good access and dug ditches for years as a kid so I was quite surgical with a pic
  14. F

    Would you?

    So the first time I tried the fenderwasher thing was on my mom's truck in 08. Never an issue. Did my truck somewhere around 2013 with no problems either.
Top