I know this is going to sound crazy but I still have to ask because there are number of very knowledgeable people on this forum who work on this drives
I'm getting closer to needing clutch repair. Right now slips over at 32mph
my question is what is the difference between forward and reverse...
Hi all,
My alternator stator output for eletric choke reads only 7v
I understand that 7v is right on idle however mine reads the same regardless of rpm and of course my choke doesn't work due to low voltage
Would this indicate the alternator problem
Otherwise I think the alternator is ok...
I have to set my idle and check the timing. As per Volvo book all running test have to be done under load with correct test propeller so how do you guys do it, how do marine shops do it (some marine shops in my area are nowhere near the water)
Does anyone have experience swapping analog trim gauge 9Faria) with digital trim gauge (volvo)
I have three wire sender, have digital gauge (round type)
when connected I only get dash on display, no numbers
what am I missing
thank you
I have a question about volvo penta trim sender (384 9411) wire identification.
According to diagram black wire is - ,black/brown is data but there is no mention of white.
is white wire only for testing?
I'm replacing analog trim gauge with digital. Gauge has 3 inputs + - and data
Hi,
New to this forum and boating in general
My question is regarding temperature alarm switch on 1999 Volvo Penta 4.3gl pwtr
The engine doesn't have oil/temp alarm and I would like to install it.
Where would the temp switch screw in, my thermostat housing doesn't have a thread on the side...