Sorry for the confusion, I mean water and. Gear oil hose, first install on the gimbal then on the transom right?
And while installing bellows: exhaust,u joint and shift bellow firstly on the transom then gimbal housing ?
Will do! I have oil hose from the bellow kit and power tune too. So install oil hose on the bell housing then in the transom right?
Whats the sequence for the bellow install? First transom then on the housing? Thanks I have to do it myself because there is a lack of tech guys in my area
Ciao,
I am planning to do my 1st bellow job on my 2007 boat, I am owner for 8 years and I want to replace my bellows just as a precaution.
I have all the tools and OEM parts, i will replace shift cable and trim senders too,
I need to replace gear oil hose and also there is a water hose in the...
Can shift interrupt switch block the ignition maybe? I don’t have any tools to check if the coil is making spark to the distributor…
Can disconnect gray (-) wire from coil help isolate the failed tacho?
Engine cranks but without starting, even when spraying start fluid doesn’t work…
I’ve got 9V at the coil +, 12v at the orange at alternator.
Kill switch is in RUN, I don’t have red circle CB at the top of the engine. Maybe fuse at the starter how to check it? All instruments works at the dash...
I remember we have noticed no 12V to the choke as well, should it be HOT with ignition ON or when the engine is running? I Think in my V6 its ON when my ignition is ON from COIL +
Yes it’s carb, ok I’ll get back when we will be at the boat.
I don’t remember if the gauges were alive when keyed on. I’ll check that.
For sure the engine was cranking a little until batteries die, and also there was continuous beep ( I assume because of no oil pressure )
Yes I have multimeter ready, I need to sneak around I couldn't find any more CB's around... thanks!
For sure there is 120Amp at the + at the starter but I assume its OK if the engine cranks?
Hello,
Im writing this post in the name of my friend from the same marina.
He said he was boating with his family then heared a pop and the motor dies...
I suspect also no charging because his batteries are drained too...
When he keys the ignititon ON the pump doesnt work we cannot hear the...
Thanks, I dont know if I have to replace the cable too or not, i dont have issues with the shifting (so far)... thanks!
I have Manual #14, do you think its enough for DIYer or maybe some videos are helpful for example with what bellow start the job etc... thanks!
