Recent content by fbriggs

  1. fbriggs

    4.3 Ignition swap

    Ordered a EST Delco with coil and all harnesses. Waiting for it to come in. Thanks for all the info I'm assuming wiring directions come with kit to wire, hook up tach, and set base timing? If not I will one back.
  2. fbriggs

    4.3 Ignition swap

    Have a 1997 Star Craft with a 4.3 (262) GM. It has a failed ICM and as you know N A. from Merc. My question is has anyone had this problem and just swapped out the Thunderbolt IV ignition system and replaced with a good HEI Distributor. Doesn't seem to much sh is uld go wrong. Please if you see...
  3. fbriggs

    Flywheel magnets

    Replacing a flywheel on my 96 mercury 25EL outboard. Finding some have 2 magnets some 4. Same pt# will they interchange.
  4. fbriggs

    Water flow out powerhead

    Have a 1996 mercury (Tracker) 25hpEL, Sn# OG6309267. Not use to the outflow restrictor streaming water and then stoping, then start again after 15-20 secs. But I think this is exactly how it's suppose to function since the tell tale hose comes directly out of the thermostat housing. So makes...
  5. fbriggs

    60 hp Mercury 4 stroke TPS question.

    throttle position sensor. On top the throttle body. This is a 60 hp 4 stroke efi 2010. Need to know if the intake needs to come off in order to get the t.p.s indexed right. Can't do it with intake mounted. Can't move tps enough to drop over the throttle shaft.
  6. fbriggs

    60 hp Mercury 4 stroke TPS question.

    Not sure if I'm posting correctly need some help. Posted twice over a week ago and not one reply. Thinking I'm doing something wrong on this site. In sure need of help with installing a T.P.S on my 2010 60hp Merc 4 stroke engine. I just don't know if anyone is even seeing my post? If anyone...
  7. fbriggs

    Low fuel pressure 60hp 4 stroke

    Me again still can't get this damn Merc running. Haven't had a lot of experience with this peticular motor. 2010 Merc, 60 hp outboard with EFI, 4 stroke. My big question is, doesn't the fuel system high pressure pump in the VST get it's running pressure totally from the fuel regulator mounted...
  8. fbriggs

    Fuel Regulator cross ref or sub numbers

    I don't believe you are looking up a 892267A50. If it crosses and you find one get back with where you found. I'll pay top dollar because every Merc dealer I've called said mid July. If you try to order non oem ( which I'm fine with) on a different site I can guarantee when you go to check out...
  9. fbriggs

    Fuel Regulator cross ref or sub numbers

  10. fbriggs

    Fuel Regulator cross ref or sub numbers

    Can anyone tell me if there is another fuel regulator that will fit the 30-60hp 4stroke motors. Merc pt# 892267A50. Merc not available till mid July boating season half over by then. Or even a good used marine store that may have either the regulator or a complete VST. Thanks
  11. fbriggs

    60hp 4 stroke TPS setting

    2010 60hp efi 4 stroke mod# 1A60413KZ. Sn# 1C112398.
  12. fbriggs

    60hp 4 stroke TPS setting

    2010 Mercury outboard 60hp efi. 4 stroke. ELPT 4S, mod# 1A60413KZ, Sn#1C112398
  13. fbriggs

    60hp 4 stroke TPS setting

    Have a 2010 60hp 4 stroke that I want to check the TPS. Any way of doing this without removing the intake.
  14. fbriggs

    Bogs of idle won't plane

    motor 2010, 60hp 4stroke efi sn#1C113678, is hesitating bad at throttle up. No power and dies if you bring rpm from high 5000 to idle. 1st pump holds 5-6 psi constant, high pressure pump only holds 30 psi constantly. I'm suspecting dirt in svt screens, pump or weak fuel regulator. My big...
  15. fbriggs

    Merc 60hp 4 Stroke bogs bad oo take off.

    2011 60 hp 4 Stroke 60 ELPT/ 1A60413KZ. Starts up good, has 42 psi fuel pressure constantly has over 10psi off vacuum pump (seems high?) Customer said in water would not get up on plane and only reached 3500 rpm bogging down. I ran out of water and with my own seprate fuel source demo ed first...
See more
Top