FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Hi there
Engine have equal 100 psi on 3 cylinders ( i was told this is low compression engine ) ,it dose not over heat and SLOW is no activated.
I've changed thermostat (pn#0436195) and didn't touch impeller yet since have strong pressure from telltale.
When i got bought the engine some one...
I'm back from the camp :)
All spark plugs have 3/8 gap
Engine runs / idle when cold but when warm up to opt temp wont idle and the shaking occur
It seams i have week spark on top and middle cylinder . When i pull of the wire from the spark plug on those 2 cylinders( one at the time lol)...
Hi
Thanks for the response about the coils and yes Ive remove the oil mixing chamber - it failed at the 1st ride .
Since then the engine runs fine with lots of power but it struggle to idle -it shakes a lot and look like is running on one cylinder with no deference if I'm applying throttle or...
Hello everyone !
Recently got an 1998 25hp 3 cylinder J25RMECA and i think I'm having spark issues
in the service manual says that the coil P/N 584826 primary resistance should be 0.28 +- 0.05 ohm and secondary resistance my meter should show 2300 +-300 ohm.
the engine came with P/N 056323...
