FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Hey folks I've just put new o rings in my trim cylinders on my merc 150 and have had no change with it bleeding down. I also did the rings on the tilt down screw hoping that would do it. What next? I haven't pulled the pump because that will suck and am still trying to figure the placement of...
Hey guys i'm trying to do the o-rings in my trim and tilt and i'm wondering what size spanner is correct. it's a 93 150 with the three cyl 3 wire tilt and trim. the pn for the spanner is 91-74951. Thanks again guys.
Hey guys I have a lovely 150hp frankenmerc that the only thing i know for sure about it has an 86 mariner 150 power head. I was told this thing was an 93 and has the tilt trim and cowling of one. To the point now. I'm trying to solve the bad load up i have on this motor at idle. I run premix and...
Hey i have a mariner 115 serial oc235793 I'm getting 2 part numbers 42909A 4 and 857005a 1 don't really know the difference or what i should look for to differentiate the two setups. thanks
Hey guys the problem i seem to have is that the carbs seem to be dumping way too much fuel into the motor. i cleaned the carbs about a week ago and it ran fine. i had to fiddle with the trim today cause of an air bubble than after i got that sorted out i tried to run it but it's dumping a lot of...
Hey guys i've been looking in at this forum for a while and now i have a good question to post. So here's my dilemma. I have a manatee 207 vc and it had an 87 125 force on it. I say had cause i just removed it (dropped #3) Now i am looking into some possible replacements and i'm wondering which...
