Recent content by devildg4671

  1. D

    E50PL4EES- 99' Evinrude 50hp 4-stroke Common problems

    Helll, I have a 99' Evinrude 50hp commonly known as a Suzuki DF50, I was wondering what are the common problems with these outboards ? I was told, mine was shot due to a common problem/leak that causes the motor to hydrolock. Is it worth rebuilding or purchasing a used low hour exact model. Any...
  2. D

    Prop-Evinrude Problem

    Hello, I purchased a Michigan Wheel Apollo Stainless Steel 3 blade prop recently for a my 1999 Evinrude 50hp 4-stroke, It came with the prop, thrust washer and hub. The problem I'm encountering, after installing it and gently tightening down the prop nut to put the cotter pin in the prop...
  3. D

    1999 Evinrude 50hp 4-stroke Starter Issues

    Please Help, Last week I tried starting my boat multiple times with times, I put a charging on the battery for about an hour. Tried again, no luck. I might have tried too many times to start it. When I noticed smoke, coming from the positive and negative wires that run from the starter. The end...
  4. D

    1999 Evinrude 50hp 4 Storke-Fuel leak

    Hey Guys, I'm new to evinrude's so I'm looking for a little help. I just tilted my outboard down, and noticed the smell of fuel. After it was fully down gas appeared to run out of the water cooling hole. So I removed the cowling and fuel poured out of the area where the carbs are located. I...
  5. D

    information-16ft Shoalrunner Skiff

    I just purchased a 1991 shoalrunner flat bottom skiff with a mercury 50hp outboard, and I cant find one bit of information online regarding this boat. So does anyone have a clue where I could find any information regarding it, the title states its a 16ft Shoalrunner, thats all the information...
  6. D

    ideas to cover battery box

    I'm looking at ways I can cover my battery box. I removed a cushioned seat that use to sit atop of the box. The inside dimension are 26" x 10 1/2 and 28 1/2. I need something sturdy but haven't came up with any ideas except for using starboard overlayed. Any ideas wouldbbe great
  7. D

    Stiletto BAY PRO-II Stainless Steel Rust spots

    I recently purchased a Stiletto BAY PRO-II Stainless Steel four blade propeller from boatownersworld.com at a great price. I installed the prop a few weeks ago and today I noticed a rust spots/stains on it. It hasn't even been in the water. Is this normal or has anyone had any problem with this...
  8. D

    transom mounted swim platform install

    I recently removed my old and rusted swim platform from the transom of my sea pro 206cc. I failed to realize it was bolted thru the transom so without damaging anything I cut the bolts off. Now my challenge is installing the new platform. I've looked around and can't find a good or easy way of...
  9. D

    Hi-Run Trailer Tires Reviews ??

    I recently went to my local boating store for new trailer tires. After arriving to pick my trailer up I noticed they used Hi-Run trailer tires made in China. Has anyone had any problems or reviews good or bad regarding these tires ? I've heard alot of people had negative comments about these...
  10. D

    Yamaha Props

    I couldn't find a forum on props regarding my 2004 Yamaha 150 txrc 2-Stroke. Basically Im looking to upgrade from the standard original prop. My owners manual states its a 14-1/2 x 17-M. What would be the ideal 3 or 4 blade stainless steel prop upgrade ? 2005 Sea Pro 206cc 2004 Yamaha 150...
  11. D

    2004 Yamaha 150 txrc Oil problem

    I'm not sure if this has been covered in any thread because I haven't found anything like this before. I have a single Yamaha 150 txrc 04', I recently noticed after flushing the motor that my main oil reservoir dropped down a couple of inches. I'm unsure of exactly where it's going. I did...
  12. D

    Yamaha 150 txrc cranking problems

    I have a 2005 Sea Pro 206cc with a yamaha 150 txrc. It cranks and run greats in the beginning. But after being anchored up for an hour or so i have a very hard time getting it to start. I usually have to prime it a few times and choke it. Which helps but usually before I get the anchor back up...
  13. D

    Fuel Gauge/Sending Unit Problems

    I have a 2005 Sea Pro 206cc that I recently filled up and changed out a battery. Soon after I noticed that my feul gauge wasn't working and was reading below empty. I used a jumper wire to test my gauge, which read full during the test, then shot back over to empty. I bought a new sending unit...
  14. D

    Installing new Speakers

    I'm looking to install speakers on my 206 Sea Pro. I was wondering if wakeboard tower speakers will attach to my t-top. I really didn't want to cut to install speakers and I really like the design.. So I was hoping someone has had some experience with tese..
  15. D

    Magic Tilt Trailer replacement axles

    Good Afternoon, I just took a look at my recent purchase and noticed some really bad rust on both axles, springs, and brakes. Its a magic tilt tandem trailer, does anyone have any experience with completely replacing the suspension, axles and braking system ? If so, whats the round about ball...
See more
Top