FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
Putting together a 1957 Evinrude Big Twin. I purchased a lower end pin drive from ebay off a 33 hp 65 Johnson. Question is what prop should I use. I have been looking for a part number, but no luck. Thanks
With my FD 11 set aside I decided to start on the TD 20 and HD 20. As I do not have a parts manual for either of these motors, I was hoping the pros here can help. Looking for the prop shaft seal part # for the TD 20. The # on it says 543870 which brings up no info. I would like to also replace...
I picked up a 14' Starcraft Kingfisher and trailer. The guy who had the boat before must have had a real small motor because he cut a square out of the transom. Its about 6 inches down and 12 inches wide. Is this a easy fix? Will it still hold the 30hp it was rated for? What can I do to repair...
I figured I'd bring this back to the pros here. Since you guys did help me alot with getting my motor running, I thought I'd search for your help once more. I decided to check the lower end after having so many problems trying to get it running, figuring that maybe the guy that sold me the motor...
I have looked for a sticky how to on this. Anyone have a link or a step by step. Like to change my fd 11 so that my plastic one line tank is universal. I really don't know where to start or what needs to be plugged? Thanks
I just picked up a few old johnson motors from a friend. I am really having issues with my 57 fd 11. I wanted to make sure that the carb, tank and lines were in good condition, I replaced the coils and points, ck'd and gapped at 0.20. I wanted to make sure that most of the motor was in good...
