Recent content by DeepCMark58A

  1. D

    Easy way to remove carpet from aluminum deck?

    As rotted as the surface is the base is stubborn, perhaps a big wire wheel will make it easier. or you could do it like old time shingles and add another layer of carpet over the top.
  2. D

    Been gone 20+ years...I'm back. Question--removing mold/crap from an old boat

    Toilet bowl cleaner step 1 on the hull. Starbright mildew remover on the seats spray it on and wipe it off.
  3. D

    rant

    Gonna be a while ER test results have to go to an orthopedic and then schedule surgery.
  4. D

    1966 Johnson 60hp won’t fully engage reverse.

    clutch dog, if it isn't grinding the gear is fine.
  5. D

    rant

    So Friday the gasoline line came off the pontoon outboard, I was trying to reach over the back deck to plug it back in when I slipped in my attempt (failed) to stay in the boat. Turns out my bad back has 2 bulging discs and that tailbone incident completely broke my tail bone off, displaced. You...
  6. D

    BF75S Honda 7.5 HP won't idle suddenly

    Add startron to your fuel.
  7. D

    Anyone affected by the Canadian Wildfires ?????

    Here in Minnesota this summer the smoke is either from up in northern MN and Canada. Canada is the cause of their own suffering with treating huge areas with glyphosate to kill everything off but pine and spruce trees.
  8. D

    Anyone affected by the Canadian Wildfires ?????

    I spent 16 in the bush on the Cranberry Portage fire that was 45 minutes south east of Flin Flon back in 2010. Longest I have ever gone without a shower. Good times
  9. D

    Really dry around here

    4" well with a 4" submersible should work, a 6" well is ok but domestic water supply is different than irrigation. Irrigation is long run times, domestic systems are filling a 60 gallon pressure tank at 7-12 gpm
  10. D

    Really dry around here

    What is the size of your well?
  11. D

    Really dry around here

    Oh well megger it each leg to ground it under 500 ohms it is a goner.
  12. D

    Really dry around here

    Take a piece of 4" PVC around the pump get a well seal for the top of the your pump will last for years. My first toy was a pump impeller I paid for my college education working for a well driller.
  13. D

    Really dry around here

    You need to have a shroud around the pump and motor to route the flow of water past the motor to cool it. You could drill a 8" well in northern WI where the ground water temperature is close to 50 degrees put a 4" submersible in there without a shroud it will burn out. Submersible motors require...
  14. D

    98 MASTERCRAFT SAM DUVALL EDITION- 2 CANISTER FUEL FILTERS?

    So the Indmar 351 is a Windsor and has 2 filters, the water/seperator is on the suction side of the pump , the PCM 351 only have 1 filter on the pressure side.
  15. D

    Intermittent starting

    If you have a bilge you have to be mindful of connections.
See more
Top