Volvo Penta 270
I am looking for tips on removal and install of the U joint crosses W/O removal from the transmission. (I am aware that with removal, we can inspect the main seal, tolerances, etc., but I am going to have an experienced VP/AQ series mechanic look at my drive come Fall/Winter)...
I just read a bulletin that said gear oil for the 270 should be the same as the engine oil. I use 10W40 in my AQ120B, but upon recommendation by a local shop that works on a number of AQ series outdrives, I have been using straight 30 Heavy Duty in my outdrive. Is this incorrect? Would like...
1978 Volvo Penta 270
I have spent hours reading up on the R&R of the pds bearing, but I'm stuck now. The front and aft seals are out, the pds shaft and pds bearing are out. I removed (broke) the small snap ring on the shaft at the bearing, but cannot remove the bearing from the shaft.
My rods (with spinning reels) lay sideways in my new rod holders. Will my rods being sideways damage my rods upon a big fish strike? Trolling for Salmon? Look at the guides.
Thanks
I need to replace the exhaust hose that connects the exhaust manifold to the exhaust pipe leading to the lower unit.
The hose is not uniform in shape, but has a manufactured bulge in the middle.
Question.
1. Do I need that hose design, or can I use a straight exhaust hose?
2. What is...
I am replacing the plugs in my AQ120B. I know the engine calls for W6DC plugs. I want to put in resistor plugs. The local Napa has cross-referenced an Autolite equivalent. I have been told Autolite are cheap plugs and to not use them.
Does anyone have suggestions or input?
Thanks
I am a new boat owner. 1978 17' deep V with a 1978 17' Calkins roller trailer, single axle. The fellow I purchased the boat from showed me how to hand load as he did not power load. When solo loading the other day, I put a small scratch in the gelcoat because I had difficulty centering the...
1978 Volvo Penta AQ120B. Ran yesterday for 45 minutes on lake. Ran great, started right up. At home, drained fresh water open system at manifold and heat exchanger. Also broke and drained lines to sea water pump. Closed system has antifreeze in it.
Temps were freezing last night and today...