#1 Does my 1986 Mercury 35hp outboard have points? My repair manual
does not shed light on things and I don't really want to pull the flywheel
to check.
#2 Besides changing the plugs what would you do for a spring tune-up?
Thanks
My 86 35Hp Merc. does not seem to be running at full power. Any suggestions on what to check or look at?
last year I had the motor tuned after I got it, not sure what all they did. Hunted in it last winter and it ran good.
This spring I did a seafoam treatment on the motor.
replaced the water...
Got my kit to replace the impeller but I am pretty sure the old impeller is in pieces. Is there a picture some were of which way the impeller blades are bent when installing the new impeller? Do they bend to the right or the left?
I have a seloc manual and it does not show or mention it.
I need to replace the water pump on my 35hp Merc. I want to do it myself but the book I have is a bit confussing.
I believe it's a 1986 model, the serial is A153384.
1. Is it that hard to do?
2. Where can I get the replacement kit?
Thanks
I have an 1986 35hp Merc with the 2 cylinder trim/ tilt. The pump motor is shot and I am not sure about the pump. The set-up uses 4 hoses, 2 to each cylinder.
Can I adapt this to one of the newer 2 hose pumps and combine hoses since they are easyier to come buy?
I am in the process of building/ putting together a boat. When I got the hull I had no controls or motor.. Now I have a new set of Mercury Controls and a 1986 35hp Mercury with power trim (Hydraulic) I am trying to figure out the wiring of the power trim.... Help!!!!
concerning The wires from...
