FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Here is the info sheet I downloaded referencing the new tool numbers in regards to the specific motors. Someone told me to use Collar #328363 & Gauge #328366, but I now see that this is not correct for my motor. I have an '85 Evinrude 50HP, long shaft (E50BELCOB). If Im reading this sheet...
Thanks Sean.
I have the second set of tools that I've listed. I've set them up and gauge the tolerances. However, (Pardon the pun) the shaft seems a bit long, maybe 1/8" inch. The tool for the Short 15" shaft model is a perfect fit with ZERO clearance... To hense my doubt. (I have the Long...
Thank you for the input. I have the shimming tools and more confidence than experience, so that makes me somewhat dangerous. I'll call my local shop today, but since I'm in Arizona, I have my doubts as to the experience of a shop that doesn't see a lot of Evinrudes.
I have an E50BELCOB, 1985 50hp that I am rebuilding the lower unit on. Everything is apart and ready for assembly, but I'm having a difficult time with the shimming specifications. The service manual calls for OMC special shimming tool #320739, which I cannot find ANYWHERE. However, I've been...
