FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
guys,
I just dont understand. I just cleaned the carb out. float was missing needle, so i replaced it. now i can keep it running only if i pump the carb full of gas and then disconnect hose!!! and then i have to hold the throttle in the start position plus hold this other piece wide open and i...
guys,
I just dont understand. I just cleaned the carb out. float was missing needle, so i replaced it. now i can keep it running only if i pump the carb full of gas and then disconnect hose!!! and then i have to hold the throttle in the start position plus hold this other piece wide open and i...
ok i recently had posted a question and i think i have fixed that problem not sure quite yet. have not tried the motor yet. i figured i would go ahead and switch the coil ignition. but i can not get the magneto off. i have read some things i can try and see if that is how i do it but info on...
I have a 1986 gamefisher outboard motor 5.0. I have very little knowledge of motors let alone boat motors!! If i tilt the motor, gas leaks out like crazy. We put new plug in it and shot some starter fluid into it. we could get it to run for like 3 to 5 secs. tops. whats going on here guys.?? i...
