FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
The mechanic that I use was just telling me that the fuel pump is going to fail because I disconnected the VRO. I plugged it and added the oil to the fuel. The motor is a 96 Johnson 150hp. Anyone ever heard of this?
I just rebuilt the carbs and put them back on and now the engine is sputtering or "coughing" at idle speeds and in neutral idle. Any ideas? I have also noticed a hesitation at throttle up. It runs fine and speeds.
I am having a problem restarting my Johnson 1996 150hp. I just went out and squeezed the primer bulb and fuel came out of this vapor separator. So I took it off and apart and there is a float and needle and a gasket in it. the needle is stuck in the seat and the gasket is busted. I am going to...
I have 1996 johnson 150hp. It cold starts great. I will run on plane for 30 min or longer and shut it off when I get to a fishing spot. when I go to leave it is hard to restart. It will start then sputter out a few times and then it goes. I just rebuilt the carbs and it still didnt help. Any Ideas?
When I launch the boat and start the engine for the first time of the day it starts up with no problem. I run out to my fishing spot turn the engine off. when I go to restart it weather it be in 10 min. or 2 hours it is hard to start. it will fire up and the die out. i have tried to rev it up...
I need to find a wiring diagram for my 1995 130hp johnson for the ignition switch. I know the purple white wire is for the choke but what about the rest?
I own a 1970 Cary 19. anybody else own a Cary. I have not found much info on this boat other than it was built by the speedboat king Don Aronow. This boat is 19 ft. long and only 6ft 6in wide. I have a 130hp on it and it does about 45mph. Its a great fishing boat. I have never seen another one.
I just replaced the selinoid because the old one was stuck in the on position and flooding the engine out. Well I put the new one on and the engine wont start. I unpluged the wire on it and it runs fine. The old one was melted on the inside which leads me to think there has to be a short on the...