FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I have a 25 3 cylinder. One cylinder cuts out at half throttle. I cleaned the carbs and replaced the fuel pump gaskets. Did a compression check 110 on all cylinders. I can unplug two cylinders and it will run no matter what cylinder is plugged. Any idea how to diagnosis the problem. I...
I have a 1998 25 hp 25mshw3. I am looking for the idle screw adjustment setting for each carb. Any information would be helpful. I think the top carb was 1-1/2 turn , middle 1-3/4, bottom 2.
1991 mercury 25 hp.
I just changed the stator because of bad fire. i was checking the fire with the plugs out and i noticed milky looking substance coming out the lower plug on the powerhead. I started inspecting it and i notice a good bit of water under the powerhead. is the head cracked or...
i have a 1991 25 hp merc i have been having problems with it i think its something with the ignition system i have a meter to check just dont know where to start. any help. the motor was running a few day ago with a miss and know it doesnt even start. it only gets fire to the plugs 1 out of...
i have a 25 hp it is very hard to start i have to pull the rope very far out and pull it fast. thats the only way i get fire to the plugs. if i just pull it normally i got get any fire to the plugs. once i get it cranked it runs very rough (seems like one cyclinder not fire to good; i get...
Anyone know where i can find a schematic or part list for a 1991 evinrude 40 hp online. I lost a piece when i was working on it and cant find were it goes. It was a small plastic piece with a spring in it and i lost it and cant find where it went.
I am going buy a spring and two bolts tomorrow and put it on my Pt-130 and i think it will be just as good as the Ba-130 break away. While my acutator is out and trying to fix it.
What you think?
Anyone know of a place where they fix the Actuators for cmc pt 130 jack plates. The one i have is not under warranty and i do not want to spend 350 on a new one. Cmc said that they do not repair out of warranty items.
My power tilt/trim works when it wants to. sometimes it goes down but wont do anything after that. Or it will go up or down a little bit then quit working. I can hear the relays clicking but no movement. ANy ideas whats the problem or problems.
