Hello all,
We are finishing up a classic Sea Craft boat that has a 1989 200hp Yamaha on the transom. This boat has the two digital gauges. All of the color coded connectors and wires are properly connected.
However, when the key is turned to on, the trim and tilt motor runs but nothing else...
Hello all,
I have a 1999 Yamaha 9.9 Four Stroke (F9.9MSHX). The motor has been running progressively worse since last fall. This spring I performed a full maintenance program. I changed the oil (lower unit and engine with YamaLube), replaced the external Yamaha Fuel/Water separator, rebuilt the...
Hello all,
We have a 1970 Classic Sea Craft. We are replacing the metal fuel tank as it was leaking badly. This tank mounts under the seat molded into the front of the console and is completely covered by the console. There are metal straps that secure the tank to the deck and a remote fill and...
Hello all,
I am working on my 1976 55hp Evinrude 2 cylinder outboard. Chasing down a no spark condition. When I purchased it the previous owner had a hacked harness on it and it was not sparking. It was then tested with a short test harness and found to have excellent spark.
Fast forward to...
Hello!
I am new to this Forum, but have been a lurker for a while. Recently, I took on a 1989 Force 85hp to repair. The gentleman complained of the engine not running right at full throttle or midrange without hitting the electric choke. So, I started by reading up on here to see what I could...