FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
My 1973 Merc 7.5 hasn't been run for several years. I finally had it in the water on Saturday and it runs great on my 12' Alumacraft boat. It has a new water pump and fuel tank. Before launching it I connected the fuel line and squeezed the primer ball until it was firm. When I primed it fuel...
1958 Alumacraft 12' boat with 1973 Merc 7.5 outboard.
Transom length: 15"
Shaft length: approx 17" (top of transom clamp to bottom of cav. plate)
The best I could measure the bottom of the a/v plate is approx. 1-3/4" below the bottom of the hull. The attached Pix will illustrate that the top of...
I have a 73 Merc 7.5 HP outboard with part of the skeg broken off. I have searched the web for replacement skegs, but I found nothing for 7.5 HP motors.
Can I dress up the edge and use the motor without the missing piece of the skeg. I plan on installing a rock guard on the motor since it will...
I have a 1973 Mercury 7.5 HP outboard that hasn't been run for many years.
I started it recently and believe it or not it runs great, but no cooling. The paint on the power head is shiney so I don't believe the motor has many hours on it.
I removed the lower unit and removed the water pump upper...
