Recent content by Charger_

  1. C

    TPM

    CDI sheet - page 3 Erratic/Advanced Timing: #2. Check DVA on white/black wire. Where is this wire?
  2. C

    TPM

    How do you test the TPM?
  3. C

    Mercury XR6 150

    I can see/know the difference between OEM/CDI. Both sheets list different specs. Both t/s doc is from CDI, so it should be the same across the board not different specs depending on what page you look at.
  4. C

    Mercury XR6 150

    Prop is a Ballistic 3 blade. No other markings found that tells the pitch. Don't believe that is the problem. If I was unable to reach max speed then that would be related to prop pitch/size. Posted two images/sheets. Both have different specs for ohms resistance for stator. Which one is...
  5. C

    TPM

    Timing Protection Module: Part#857185T1 Can anyone explain its purpose/function? Does this have capacitors that store DC? Does this work in conjunction with the trigger?
  6. C

    Mercury XR6 150

    TPM would not be at fault since I have spark on all CDM? Is that correct?
  7. C

    Mercury XR6 150

    Can the ign output be tested for specs OR is that where the CDM test harness comes into play?
  8. C

    Mercury XR6 150

    According to CDI, Trigger specs 1100-1400 ohms / 4+V Trigger: P/B 896 ohms 4.9V W/R 1082 ohms 6.3V B/Y 1155 ohms 6.3V Peek volts check out, just low ohms output. Signal is coming from the trigger. If it's not firing at the TDC, would having a bad trigger cause this issue OR is this more a...
  9. C

    Mercury XR6 150

    Is the Stator/Trigger within specs?
  10. C

    Mercury XR6 150

    idle mixture screws do nothing more than help with idle. They're set 1 1/2 turns out +-1/2.
  11. C

    Mercury XR6 150

    Anyone able to provide any insight to the questions or have experienced this issue?
  12. C

    Mercury XR6 150

    Stator and Trigger - Are they within specs? Can you test the control module input/output? Do I need to get a CDM wire harness to test inline?
  13. C

    Mercury XR6 150

    According to CDI, stator ohms reading on one sheet is 380-430, other sheet 660-710. Which is correct? Stator: 429 ohms 221V Trigger: P/B 896 ohms 4.9V W/R 1082 ohms 6.3V B/Y 1155 ohms 6.3V Good spark able to jump 7/16 gap on all CDMs. Cylinder compression is in the 130's and within 10%...
  14. C

    Merc XR6 service manual

    Anyone know where to get a service manual just for a '03 Merc XR6 150 / ID#1150454AD?
  15. C

    Mercury XR6 150

    02 Mercury XR6 150 carb engine rebuilt carbs - needle/seat/gaskets rebuilt fuel pump / new fuel line new plugs /gapped new water pump /stats / poppet relief valve When I throttle up the boat never planes out. Outboard never dies. Just falls flat. Like it has no power / or lack of. Thought it...
See more
Top